After my last endeavor to scratch build the 50 gun Leopard I wanted to try another ship to see if I could improve the process at all. I found the mother load site for original ship plans at http://collections.rmg.co.uk/collections.html. One of the sets I downloaded was for the 80 gun French built ship of the line Tonnant.
Tonnant Class Sane-Border design of 1787, she was launched at Toulon between 1791-92. Tonnant was one of the 18 ships of the line left in French hands when Toulon was abondoned by the British in 1793. She was captured by the British August 1st, 1798 at the Nile. She lay eighth in line directly astern of de Bruey's flagship the 120-gun Orient. Tonnant's armament at capture was as follows:
Lower gun deck: 30 iron long 36 pounders, and two brass long 36 pounders.
Upper gun deck: 32 iron long 24 pounders, and two brass long 24 pounders.
Quarter deck: 12 iron long 12 pounders, 2 brass long 12 pounders.
Forecastle: 6 brass long 12 pounders'
Poop: 6 brass 36 pound carronades.
Total: 92 guns
Broadside weight: 1,212 pounds (James says 1,287 pounds)
Tonnant was 194 ft 6 ins long on the gun deck, 51 ft 9 1/4 ins at the beam. Depth of hold was 23 ft 3 ins, and 2281 tons burthen. Her complement was 700 men and boys.
As with the Leopard, I first scaled the plans to 1/1200 (194' 6" = 2 1/8").
After printing them out I glued the deck plans to 1/16" balsa sheet, then cut them out with a sharp Xacto blade.
Next I glued the decks together, one on top of the other. A little sanding to smooth the edges was quite easy with the soft wood.
Using the ship profile, I traced the stern quarter galleries onto the 1/16" balsa and cut the starboard and port galleries out, then glued them to the stern quarters of the hull. Sorry I didn't take pictures of this. I did not do this for the Leopard.
I then cut out the left and right ship profiles and glued them to the hull sides, starting at the extreme stern and joining at the prow peak.
I glued the stern gallery plan to a piece of 1/8" balsa and cut it out. I used a dental tool to press in the windows and other stern details on the plan. Then I glued it to the stern. Next I cut strips from heavy bond paper and use the Xacto blade to snip port hatch covers to glue to the hull at the ports indicated on the profile plans.
To seal and stiffen the soft paper, I applied a coat of Americana Triple Thick Gloss Glaze. This dries very hard and is paintable.
Next I used bits of card, balsa and plastic credit card to make the deck furniture and gun carriages.
At this point, after comparing the height to one of my Langton 80 gun ships, I decided to add the orlop deck to the bottom to lift the ship.
A view of the stern with the orlop:
For lanterns I cut 3 small bits of thin gauge insulated wire. I cut half of the insulation away then slid the bit that was left down just enough to show the wire. I stuck the other end of the wire into the soft balsa stern gallery.
Next was the first coats of paint.
Then I made the base like I usually do out of acid free matt board and vinyl spackle. Painted with navy blue and dry brushed with sea blue-green.
Now I started working on the masts and sails.
I start from the stern installing the mizzen mast and sails, one at a time, attaching the buntlines and leechlines that help hold the sails to the mast.
The standard rigging is next.
And the finished ship: